Hi all,
I've acquired a Mephisto Berlin 68000 with the official HGN 5004A adapter but the power socket in the Berlin is very recessed and the pin seems short, consequently the adapter round plug doesn't stay in the slot or power the Berlin without holding it in place.
Has anyone else noticed this problem or maybe my socket pin has been partially snapped off.
Here's a picture, any ideas anyone?
Cheers,
Al
Mephisto Berlin 68000 connector to adapter?
Moderators: Harvey Williamson, Steve B, Watchman
Forum rules
This textbox is used to restore diagrams posted with the fen tag before the upgrade.
This textbox is used to restore diagrams posted with the fen tag before the upgrade.
-
- Full Member
- Posts: 679
- Joined: Mon Aug 29, 2016 8:31 pm
- Location: Cheshunt, Hertfordshire, UK
- Scally
- Full Member
- Posts: 970
- Joined: Sun Jun 05, 2016 5:44 pm
- Location: Bermondsey, London
- Contact:
Thanks Guys,
The HGN 5004A power supply says 8v although most sites say its 9v.
I swapped it with a switchable adapter I use for the Polgar Exclusive at 7.5v which has a shorter connection, this works fine on the Berlin.
I’m hoping the Berlin Power supply at 8v will not harm the Polgar Exclusive which I’m sure has a regulated board?
Cheers,
Al.
The HGN 5004A power supply says 8v although most sites say its 9v.
I swapped it with a switchable adapter I use for the Polgar Exclusive at 7.5v which has a shorter connection, this works fine on the Berlin.
I’m hoping the Berlin Power supply at 8v will not harm the Polgar Exclusive which I’m sure has a regulated board?
Cheers,
Al.